22
SPECIFIC SAFETY RULES
Do not direct the tool towards people, pets or other
animals.
Never eject the caulking medium on the compressor.
OPERATION
Technical data
Model No.: 9045784
Max. Pressure: ....................................................... 90 PSI
Cartridge size: .......................................C3 (1.97” x 8.46”)
1) Connect the caulking gun to the compressor as
explained in the Compressor manual at chapter
“OPERATION - USING THE AIR COMPRESSOR”.
2) Remove the end cap (A) from the gun (Fig. 20).
3) Drop the cartridge, containing the caulking medium
into the tube (Fig. 21).
4) Cut the end of the nozzle off (Fig. 21), preferably at an
angle - experience will determine the ideal angle, and
amount of nozzle to cut off, for the job in hand.
5) Screw back the end cap on to the gun firmly (Fig. 22).
6) Thread the end cap over the cartridge nozzle (Fig. 23).
7) Connect the air supply, turn ON and approach the
work. Press the trigger (B) so that caulking medium
is ejected. To stop, release the trigger. Be aware that
medium will continue to be ejected for a short period
until pressure drops. You should make allowances for
this.
MAINTENANCE
Run a few drops of oil through the tool. It may be entered
into the tool air inlet, ensuring the strainer is clear, or into
the hose at the nearest connection to the air supply. Then
run the tool. A rust inhibitive oil, available from auto supply
stores etc., is acceptable.
Be aware that factors other than the tool may effect its
operation and efficiency, such as reduced compressor
output, excessive drain on the airline, moisture or
restrictions in the line, or the use of connectors of improper
size or poor condition which will reduce air supply. Grit or
gum deposits in the tool may also reduce efficiency. This
condition can be corrected by cleaning the air strainer and
flushing out the tool with gum solvent oil, or failing this, the
tool should be disassembled, thoroughly cleaned, dried
and re-assembled.
Keep the tool clean at all times.
AIR CAULKING GUN
AB
Fig. 21
1
2
Fig. 20
WARNING:
Ensure the air supply is disconnected before filling the
grease chamber.
Fig. 23
Fig. 22
To Next Page
Loading...
