Finn HydroSeeder T330

Other manuals for Finn HydroSeeder T330

Practical Service Guide For The Parts Professional51 pages

Parts And Operator's Manual84 pages

Questions and Answers

T
Tina DeleonAug 11, 2025
What to do if my Finn Seeders is plugging or clogging?
- E
  Edward NorrisAug 11, 2025
  If you observe a change or stoppage in the spray pattern, it indicates an obstruction in the discharge nozzle, potentially due to foreign objects or dewatered mulch. You can clear the sump by backflushing through the discharge plumbing with the water supply hose. Alternatively, remove the drain plug and use a long pole to clear obstructions in the sump area before replacing the drain cap. Using a pipe or pole through the loading hatch opening can also dislodge obstructions.
J
James BennettAug 17, 2025
How to prevent foam in the tank and air entrainment in Finn Seeders?
- S
  seanlawrenceAug 18, 2025
  To address foam and air in the tank of your Finn Seeders, consider the following steps: * As the slurry level decreases, reduce the agitator speed. * Introduce 2 to 3 oz (59 to 89 ml) of an antifoaming agent into the tank. * If a specific additive is causing the issue, add it last, or avoid using it altogether, unless it’s the water. * Minimize recirculation time. * Open the pump suction bleed valve to release trapped air in the pump or suction line, and close it once the air is gone.
M
millervictoriaAug 23, 2025
Why does my Finn Seeders Discharge Boom or Nozzle Camlock Fittings leak?
- D
  Dana LiuAug 23, 2025
  Leakage in the Discharge Boom or Nozzle Camlock Fittings of your Finn Seeders is often due to a worn or missing gasket. The suggested solution is to replace the gasket.
R
Robert DuffyAug 30, 2025
What to do if the rubber seal is damaged on Finn Seeders Suction Pipe Clamps?
- L
  laura44Aug 30, 2025
  If the rubber seal on your Finn Seeders Suction Pipe Clamps is cracked, pinched, torn, or missing, you should replace it. Always grease the seal before clamping it shut.
M
Megan MitchellSep 4, 2025
What to do if the rubber seal is damaged on Finn Seeders Pressure Pipe Clamps?
- K
  Kenneth JacksonSep 4, 2025
  If the rubber seal on your Finn Seeders Pressure Pipe Clamps is cracked, pinched, torn, or missing, you should replace it. Always grease the seal before clamping it shut.