Need help?Do you have a question about the Finn HydroSeeder Series and is the answer not in the manual?
Addresses leaks in suction or discharge lines, including clamp joints, nozzle connections, and swivel joints.
Addresses leaks originating from the pump, specifically around the shaft or suction cover.
Check bolt tightness and replace worn seals. Access part breakdown for specific machines.
Guides to identify leaking hydraulic components and consult the parts department for seal kits or replacements.
Check impeller debris, bearing temperature, and clutch coupling for vibration causes.
Check impeller tolerance, nozzle openings, and belt tension for consistent low pressure.
Consider material properties and cold weather effects on agitator speed and recirculation valve.
Inspect piping for clogs, backflush, or disassemble and clean the unit if necessary.
If the pump is turning, check suction/discharge piping for clogs and backflush if needed.
If the pump is not turning, check clutch engagement and related components.
Details troubleshooting for electric or mechanical clutches that fail to engage, covering power and adjustments.
Instruction to loosen the clutch according to adjusting instructions.
Instruction to tighten the clutch according to adjusting instructions.
Instruction to tighten the clutch according to adjusting instructions.
Check hydraulic oil, control cable, and pressure. Outcomes include low, spiking, nonexistent, or correct pressure.
Inspect agitator paddles for bends, straighten or replace, and realign the agitator.
Directs the user to the relevant leaking complaint section for troubleshooting.
Check torque arrestors for wear and inspect agitator for movement hitting the tank.
Check coupling tightness, shaft alignment, and torque arrestors for acceptable movement.
General| Brand | Finn |
|---|---|
| Model | HydroSeeder Series |
| Category | Industrial Equipment |
| Language | English |
To Next Page