3. Ensure that the built-in cutter is on one !
of the edges of the device.!
Pull out the an suitable length.!
Adapt the length so as to leave at least!
7 cm between the contents of the bag !
and the opening of the vacuum bag.!
Only use original film from Finnvacum.!
!
!
4. Lower the included cutting tool, carefully!
pull the cutter from one side to the other!
!
!
!
5. Put the short end of the film on top of the!
sealing brake and make sure that the entire!
short end is in the vacuum channel.!
!
!
!
!
!
6. Close the lid and press the handle completely.!
To Next Page
Loading...