Note: The appliance reaches a very high vacuum pressure during the
vacuum sealing process. In order to avoid that sensible contents is
influenced by the high pressure, keep an eye also on the vacuum bag and
press the Manual Seal button, if you want to interrupt the process before
time. In such case, the appliance turns off the pumping and switches to
sealing of the vacuum bag. !
!
8. Lift the handle to open the lid and remove the!
vacuum bag. !
!
!
!
!
!
!
!
!
!
9. Wipe off any possible liquid or particles in the vacuum channel after each vacuum packing
process.!
10. Make sure that no liquid is aspirated into the appliance. Any consequential damages will not be
covered by the warranty.!
!
Pulse/Vacuum function !
This function is preferred for vacuum packing, when you want a slight vacuum effect such as e.g.
tomatoes, chips or similar. Or, if you have moist raw materials or a sauce, where you just want to
drain air from the bag and then stop the appliance before the liquid is compressed.
Press the Sealing button to select the speed depending on the product to be vacuum packed: Choose
“Dry” for dry raw materials, “Moist” for fragile/ moist contents and a more gentle speed. The
“Extend” setting is in particular suitable for soft raw materials and raw materials with a sauce.
Press the Pulse Vacuum button several times until you get the wanted result. Press the ”Manual
Seal” button to seal the bag, wait until the light goes out and the sealing is ready.
After use, unplug from the wall outlet. Press the handle of the appliance,
but do not switch off the appliance in order to avoid the packages being
deformed, which may affect the functioning of the appliance.
Vacuum packing with a vacuum container!
1. Position the appliance on an even surface and plug to a wall outlet, turn on the switch on back of
the appliance to ”I” (the signal lamps Sealing Time/Dry and Vacuum/Normal will go on).!
2. Make sure that the vacuum container and the lid are clean and dry.!
3. Put the raw materials in the vacuum container, but be careful not to exceed the maximum level.
To Next Page
Loading...