4.2 STORAGE
The machine must be stored in a closed and dry place if not immediately installed in order to keep every part
safe.
Relative humidity must be lower than 80% and the storage temperature must be between 3°C ≤ t ≤ + 45 °C.
4.3 INSTRUCTIONS TO UNPACK THE MACHINE
¾ Cut off the bands being careful of the elastic reversion
¾ Take away on the base of the cartoon the clips that keep it together with the pallet.
¾ Where plywood is take away the clips at both sides and at the base of each panel.
¾ Cut off the clips that stop the machine.
¾ Put the machine at ground level.
4.4 HANDLE THE UNPACKED MACHINE
¾ Check the machine and mount the batteries if not installed.
¾ To displace it, after use, take off the battery cables, the brushes and the squeegee; to deplace it
through a longer space pack the machine once again in its own package.
4.5
BATTERIES INSTALLATION
To install the batteries follow the instructions as below :
¾ Raise up the battery-cover chain guard;
¾ install the batteries in the suitable slot being sure that no breakings are in the battery cases;
¾ never add distilled water after charging the batteries;
¾ clean up the surfaces needing to be connected ;
¾ Battery handling is made easier by handles on both sides.
4.6 CHARGER INSTALLATION
The battery charging must be done, as previously reminded, predisposing a suitable suction system of gases
coming out during charging. Alternatively it must be done in a dry and airy place, far from heat sources and
corrosive environments.
Protect the electrical system with a delayed switch or with a more capacity fuse than the charger.
Follow the polarity instructions for the battery inlet.
To Next Page
Loading...