Version:B
- 3 -
alarm will silence to indicate that the alarm is in a temporarily
desensitised condition.
The smoke alarm device will automatically reset after
approximately 10 minutes, if after this period, particles of
combustion are still present, the alarm will sound again.
The alarm silencer (silence mode) can be repeatedly until the air
has been cleared of the condition causing the alarm.
CAUTION: Before using the alarm silence， identify the
source of the smoke and be certain a safe condition exists.
NOTE: Dense smoke will override the alarm silencer and will
sound a continuous alarm again.
DANGER: If the alarm sounds, and it is not being tested, it
means the unit is sensing smoke,
THE SOUND OF THE ALARM
REQUIRES YOUR IMMEDIATE ATTENTION AND ACTION.
Maintenance and Cleaning:
The alarm should be cleaned at least once a year
·To clean your alarm, remove it from bracket on ceiling, you
can clean it by using compressed air or a vacuum cleaner
hose with a soft brush attachment. Blow or vacuum around
the perimeter of the alarm to remove dust and dirt and debris.
The outside of the alarm can be wiped with a damp cloth but
you use a wet cloth in order to avoid water entering the inner
of alarm.
·After cleaning , reinstall it and test it by pressing the Test
button. The alarm should be replaced if cleaning can’t restore
the alarm to normal operation.
·This alarm has a low battery monitor which will cause the
alarm to “chirp” approx every 40 seconds and the red LED
flash once at the same time for a minimum of thirty days
when the battery gets low.
If there is a defective battery or other failures, you can refer
to “Trouble shooting” for solution, or deactivate this alarm to
stop nuisance alarm which is caused by a failure of their
function. If there are still failures during warranty, you can
return to your retailer.
Don’t paint the unit. Paint will seal the vents and interfere
with the sensor’s ability to detect smoke.
NOTE: 1.REGULAR WEEKLY TESTING IS REQUIRED!
2.Must reactivate alarm before use if you deactivate it.
Replacing the Alarm
It is recommended this alarm should be replaced ten years from
the date of manufacture. This date has been provided on the
product label which is located on the back of the alarm.
WARNING: The battery is sealed in cover and not
replaceable. Please replace another new alarm if the low
battery chirp occurs.
IMPORTANT: Do not attempt to remove the cover to clean
inside. This will affect warranty.
Repair:
If the alarm is not operating properly, and is still under
warranty, return it to the original place you buy. Pack it in a
well-padded carton, and ship to the original place you buy.
If the alarm is no longer under warranty, please replace it
immediately with a comparable alarm.
Caution: Do not attempt to repair the alarm. It will affect
your warranty.
Trouble shooting:
Problem Trouble shooting
Smoke alarm device
does not sound when
tested.
1. Must activate alarm before
installation.
2. Clean smoke alarm device.
Please refer to the
“maintenance and cleaning”
section.
3. if there are still failures during
warranty, you can return to
your retailer.
4. if the unit is out of warranty，
please replace another new alarm.
The alarm “chirp” with
red LED flashes once
every 40 seconds.
The battery is under low battery
status， please replace the smoke
alarm device.
Smoke alarm device
chirp occurs every
40 seconds（alarm goes
into fault mode）.
Clean smoke alarm device. Please
refer to the “maintenance and
cleaning” section. Purchase and
change another smoke alarm device
if the problem still exist
Smoke alarm device
sounds, unwanted
alarms intermittently or
when residents are
cooking, taking
showers, etc.
1. Press test button to pause alarm.
2. Clean smoke alarm device.
Please refer to the “maintenance
and cleaning” section.
3. Move smoke alarm device to new
location and press test button.
The alarm sounds
different from it is used
to. It starts and stops.
1. Clean smoke alarm device.
Please refer to the “maintenance
and cleaning” section.
2. if there are still failures during
warranty, you can return to your
retailer.
3. if the unit is out of warranty，
please replace another new alarm.
To Next Page
Loading...