B:noisreV
- 4 -
How to deactivate the smoke alarm:
Press test button and hold it for above 10 seconds until LED
flashes rapidly (flash 5 times per second), then press Test button
rapidly for at least 6 times within 5 seconds (or within during
LED flashes rapidly), and the unit will generate a “beep”
indicates the production goes into inactivation status There will
be no any functions at this status, you must reactive it before
use, Please refer to the chapter "installation" for activating the
product
Note: Deactivate this alarm if you need disposal it or stopping
nuisance alarm which is caused by a f
ailure of their function
Practice Fire Safety:
If the alarm sounds, and you have not pushed the test button,
it is warning of a dangerous situation, your immediate response
is necessary. To prepare for such occurrences, develop family
escape plans, discuss them with all household
members, and practice them regularly.
1: Expose everyone to the sound of a smoke alarm device and
explain what the sound means.
2: Determine two exits from each room and an escape route to
the outside from each exit.
3: Teach all household members to touch the door and use an
alternate exit when the door is hot, instruct them not to open
the door if
the door is hot.
4: Teach household members to crawl along the floor to stay
below dangerous smoke, fumes and gases.
5: Determine a safe meeting place for all members outside the
building.
What to Do in Case of Fire:
1: Do not be panic; stay calm.
2: Leave the building as quickly as possible. Touch doors to feel
if they were hot before opening them. Use an alternate exit if
necessary. Crawl along the floor, and do stop to collect
anything.
3: Meet at a pre-arranged meeting place outside the building.
4: Call the fire department form outside the building.
5: Do not go back inside a burning building. Wait for the fire
department to arrive.
Note: These guidelines will assist you in the event of a fire,
however to reduce the chance that fires will start, practice fire
safety rules and prevent hazardous si
tuations.
TOTAL HOME PROTECTION
Diagram 2
Warranty Information:
Company warrants to the original consumer.
Purchase each new smoke alarm device to be free from defects
in material and workmanship under normal use and service for
a period of 10 years from the date of purchase. This warranty
does not cover damage resulting from accident, misuse or abuse
or lack of reasonable care of the product.
In no case shall company be liable for any incidental or
consequential damages for breach of this or any other warranty
express or implied，whatsoever. The bad product can be mailed
to the following address with a detail explanation of problem.
Where is the best to be Installed:
·Install the first alarm in the immediate area of the bedrooms.
Install additional alarms to monitor the exit path, as the
bedrooms are usually farthest from the exit. If more than one
sleeping area exists, locate additional alarms in each sleeping
are (see Diagram 3).
·Install additional alarms to monitor any stairway as stairways
act like chimneys for smoke and heat.
·Install at least one alarm on every floor level ( see Diagram 4)
·Install an alarm in every bedroom.
· Install an alarm in every room where large electrical
appliances are operated (for example portable heaters ).
·Install an alarm in every room where someone sleeps with the
door closed. The close
d door may prevent an alarm located
outside from waking the sleeper.
·Smoke, heat, and combustion products rise to the ceiling and
spread horizontally. Mounting the smoke alarm on the ceiling
in the centre of the room places it closest to all points in the
room. Ceiling mounting is preferred in ordinary residential
construction.
To Next Page
Loading...