6. To download a specific page: click the DWLoad
button on the page in question.
To Download several pages:
– select the required page from the Pages menu,
right click, Select (a ü on the page Icon indicates
that it will be downloaded);
– repeat the procedure for all the required Pages;
– right click again then select DWLoad.
+
To download a group of pages, select the root.
For example: to download all the Configuration related
pages, select Configuration from the Pages menu; to
download All the Pages, select J400 from the Pages
menu.
7. To view the Control panel parameters — work care
-
fully through point 6 then select UPLoad instead of
DWLoad.
8. To exit the Programming session — connect the
jumper 65 to the second and third terminals on
the 3-pin terminal strip marked PRG on the Main
Board. The Control panel will Reset automatically.
n
Restoring Factory Defaults
In order to restore factory defaults, press the Reset but
-
ton for 5 seconds when the Control panel is in Program
-
ming status. A series of beeps will signal that the
Control panel has restored the factory defaults.
44 Conventional Fire Panels J424/J408
To Next Page
Loading...
