FIRECORE G20 - Operation Modes

Operation Modes
General Operation Notes:
• Push the latch to open the battery cover, insert two new AA
batteries, following the polarity (+/-) as indicated on the inner of
the compartment.
• Press or slide power switch to unlocked position to turn the laser
tool ON. The laser tool projects one bright green cross line, short
press the top button to control the brightness of laser line. Slide
the power switch to lock position to turn the tool OFF.
• Always turn off the tool before installing or replacing the batteries.
• Remove the batteries from the tool when not using it for
extended periods.
• Do not mix old and new batteries.
• The 2 AA batteries should match each other in brand and type.
Self-leveling Mode
• Self-leveling is enabled when the laser tool is switched to
unlocked position.
< 5 >