Vaping Loose Leaf
USING LOOSE LEAF
• Touch and glow. Place fingers on both touch sensors to
start heating.
IMPORTANT: Place fingers lightly on touch sensors (as if
you are tapping a smart-phone). Do not press down or
use excessive force.
• The LED will blink green two times then turn solid
green. Solid green means it’s ready. Watch for the glow!
IMPORTANT: The Firefly will turn off after 30 seconds
of holding the touch sensors, and the heating coil will
not glow as bright towards the end of a vape session.
• Continue to hold the touch sensors while you inhale for
10 seconds with a long, deep draw.
IMPORTANT: For a denser vapor, inhale more deeply
for a few more seconds. To further customize vapor, See
the Tips and Tricks section later in this document.
• Release touch sensors to stop heating.
• After 8-10 draws, you can stir the contents of the
heating chamber get another dense 3-4 draws from
your bowl.
08
To Next Page
Loading...
Need help?
General
