Vaping Concentrates
USING LOOSE LEAF
• Touch and glow. Place fingers on both touch sensors
to start heating.
IMPORTANT: Place fingers lightly on touch sensors (as if
you are tapping a smart-phone). Do not press down or
use excessive force.
• The LED will blink green two times then turn solid
green. Solid green means it’s ready. Watch for the
glow!
IMPORTANT: The Firefly will turn off after 30 seconds of
holding the touch sensors, and the heating coil will not
glow as bright towards the end of a vape session.
• Continue to hold the touch sensors while you inhale
for 10 seconds with a long, deep draw.
IMPORTANT: For a denser vapor, inhale more deeply for
a few more seconds. To further customize vapor, See the
Tips and Tricks section later in this document.
• Release touch sensors to stop heating.
• Make sure to take an extra long pull on your first
draw from your concentrates bowl. This allows all the
concentrate material to melt into the pad so it can
vaporize during the course of the rest of your bowl.
010
To Next Page
Loading...
Need help?
General
