8
4. Attach the Post/Post Support Plate (F) to the Post Supports (H).
Align the Post/Post Support Plate (F) with the holes in the tops of
the Post Supports (H) and insert M6x20 Bolts through holes.
Secure on the underside with M6 - Nuts. Hand tighten initially then
tighten with a wrench when all bolts have been inserted.
Slide the Tank Housing (E) over the Post and rest on the Base.
Hardware Used: 6 x M6x20 Bolt
6 x M6 Nut
5. Affix the Burner Support Brackets (D) to the Head Assembly
using M5x10 Screws and M5 Nuts (2 per bracket/6 total of each.)
Lift up the Tank Housing and support it on the Post Supports.
Slide the Gas Hose/Regulator (G) up through the bottom of
the Post and out of the top. Screw the Gas Hose onto the end
of the Head Assembly. Tighten with a wrench to make sure it is
secure. Then attach the Head Assembly (C) to the Post with
4 - M6x10 Bolts. Tighten the bolts.
Hardware Used: 6 x M5x10 Screw
6 x M5 Nut
4 x M6x10 Bolt
To Next Page
Loading...