Firesense 63695 - Assembly; Preparation and Base Assembly; Base Assembly Hardware

1
¸¸gLg¿Ág¿Úµg¿¡Á¿L>¸g[¿U>Ág¿Door Pane D,¿Ç¿Side Panels E\¿
>U½*>g¿\¿Door Frame Leg \¿and 2¿Support Legs ¦
Screw -¿Å_¶ O into the holes in the sides of all four gy¶\¿
including the leg pre-assembled to the door¦
Beginning with Door Frame Leg \¿¿Ág¿gy¶¿>_¿*>g¶¿
ÁygÁgµ¿>¸¿¸Ñ¿LÓ¿ÚÁÁy¿Ág¿g¸¿¿Ág¿¸_g¸¿t¿Ág¿-_g½
*>g¶¿Á¿Ág¿-¿Å_¶¿¸Á>g_¿g>µgµ¦
/¿¸gUɵg¿Ág¿gy¶¿Á¿Ág¿*>g¶\¿¡>Ug¿>¿7>¶g³¿Q\¿then a
Spring Washer R onto each Stud,¿then thread a Nut S onto
each -¿Å_.¿Do not tighten the hardware until the entire base is
assembled.¿Then\ ÚµÓ¿ÁyÁg¿>¿Nuts with the Wrench V,¿
but DO NOT½"6ERTIGHTEN.
3ZY
1JL
5FSJQ
8UWNSL
<FXMJW
<FXMJW






