Firesense 63695 - Assembly; Tank Support and Table Top; Tank Support;Table Top Hardware

6
2
3
Hardware Used:
Once all panels are bolted together,¿turn the table base
upside-down,¿then attach Tank Support to Leg¶ / by
aligning Ág¿holes at each end of Tank Support Bar with Ág¿
holes at the bottom of g>U Leg.
Insert Bolt P throuyh Washer Q Ág¿into holes.¿Tighten gently
with Hex Wrench W.¿Then attach Tank Support µy¿Lµ>UgÁ to
the leg of Door Panel D by aligning Ág hole in front of Tank
-upport Ring with Ág¿g¿¿Ág¿gy¦
Insert Bolt P through Washer Q and then into the hole.¿Tighten
with Hex Wrench W¦
*>Ug¿/>Lg½/¿C so underside faces up.¿Screw w¿-¿Å_¶¿M into¿
the holes on tg¿/>Lg½/¿É¸y¿-U³gÍ_³Ìg³¿U.
/g¿U>µgtÉÓ¿Áɵ¿Ág¿>¸¸gLg_¿Úµg¿¡Á¿L>¸g¿É¡¸_g_Ñ¿
>_¿>y¿Ág¿g¸¿¿Ág¿Á¡¿t¿Ág¿
gy¶¿ÑÁ¿Ág¿-¿Å_¶½
¿Ág¿/>Lg½/¦
*>Ug¿Ág¿g¸¿Ðgµ¿Ág¿-¿Å_¶¿>_¿¸gUɵg¿g>U¿ÑÁ¿7>¶g³¾
-³y½7>¶g³¼ Å¿¿N as illustrated.
Tighten wÁ¿7³gU¿V.¿/g¿¡>Ug¿*>¶¿U½>¶¿T¿Ðgµ¿ Å¿¶¦


&

