Firestone 2097 User Manual

I
NSTALLATION INSTRUCTIONS
Congratulations on your purchase of a new Level Command
kit. This kit was designed to provide inflation control of your
air helper springs. This kit will be an asset to your vehicle,
meeting nearly all of your air supply needs.
Please take a few minutes to read through the instructions,
identify the components, and learn how to properly install your
Level Command kit.
N
OTE
:
The Level Command kit can be used with all air helper
spring products. If you are installing an air suspension system,
do not install the air line tubing to the air springs as stated in
the suspension system instruction manual. If you are adding
the Level Command kit to an existing air suspension system,
you will need to deflate the air springs and remove the air line
tubing.
NOTE ON CONNECTING THE AIR LINE TUBING:
Cut the air line tubing as squarely as possible. To connect
the air line tubing to the fittings, push the tubing into the fittings
as far as possible. If for any reason the tubing must be removed,
first release the air pressure from the air helper spring. Push the
collar toward the body of the fitting and the pull out the tubing.
To reassemble, make sure the tubing is cut squarely and push
the tubing back into the fitting.
T
OOLS REQUIRED
:
• 3/16"
DRILL BIT
• 3/8"
DRILL BIT
• 1/4"
DRILL BIT
• P
OWER DRILL
• W
IRE CRIMPER
/
STRIPPER
• P
LIERS
• P
HILLIPS SCREW DRIVER
• U
TILITY KNIFE
• (2) 7/16" WRENCHES • CENTER PUNCH
0 150
30
120
60
90
200
400
600
800
1000
psi
kPa
PSI
SINGLE AIR CONTROL PANEL 1
COMPRESSOR 9285 1
RELAY HARNESS 9307 1
30 FT. AIR LINE TUBING 1
STRAIGHT FITTING 3055 1
T-FITTING 3025 2
2097 / 2227
P
ARTS LIST
L
EVEL
C
OMMAND
10 -32 x 1" MACHINE SCREW 7
10 -32 LOCK NUT 7
#10 FLAT WASHER 1
4
RING TERMINAL 1
WIRE CONNECTOR 2
NYLON TIE 15
PERFORMANCE SUSPENSION PARTS

Firestone 2097 Specifications

General

Brand	Firestone
Model	2097
Category	Control Unit
Language	English

Summary

Installation Instructions

Level Command Overview

Introduction to the Level Command kit, its purpose, and benefits for vehicle air suspension.

Important Notes

Key notes regarding the compatibility and installation of the Level Command kit with air helper springs.

Connecting Air Line Tubing

Detailed instructions on how to properly connect and disconnect air line tubing to fittings.

Air Line & Wiring Diagram

Mounting and Routing Steps

Mounting the Control Panel

Steps for selecting a location and mounting the control panel to the vehicle's dashboard.

Compressor Preparation and Mounting

Instructions for preparing the compressor, installing fittings, and securely mounting it.

Routing Air Lines

Guidance on routing air lines from the compressor to the control panel and air springs.

Electrical Wiring and System Check

Routing Electrical Wire

Instructions for routing and connecting electrical wires for the relay and control panel.

Wiring Control Panel Illumination

Steps to connect the control panel's illumination wire to the vehicle's dashboard lighting.

System Check and Leak Detection

Procedures for testing the installed system, inflating air springs, and checking for air leaks.

System Operation

Explanation of how to use the Level Command kit to inflate and deflate air springs.