English Customer Service: 1-844-FIRMAN1Page 15
6. Move choke lever
located on engine to
“START” position.
8. Move the choke lever
to the “RUN”
position.
9. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
Starting the Generator (Electric Start-LPG)
1. Before starting the generator, check for loose
or missing parts and for any damage which
may have occurred during shipment.
2. Check oil level .
NOTE: When the fuel selector switch is turned
to the “LPG” position, the indicator light will
become RED up to 4 minutes(before goes off).
Starting the engine successfully during these 4
minutes will turn the indicator light GREEN. 6.
Disconnect all electrical loads from the generator.
Never start or stop the generator with electrical
devices plugged in or turned on.
To Next Page
Loading...
