English Customer Service: 1-844-FIRMAN1Page 17
Let the generator run at no-load for two
2.Ensure circuit breaker on control panel is in minutes to stabilize internal temperatures
on position. of the engine and generator.
3.Plug in and turn on the desired 120 Volt
2. Turn the fuel selector switch to OFF (O)position.
AC, single phase, 60Hz electrical loads. It is better
to attach the item with largest load first.
Connecting a generator to your electric utility
company's power lines or to another power source
may be against the law. In addition this action, if
done incorrectly, could damage your generator
and appliances and could cause serious injury or
even death to you or a utility worker who may be
To Next Page
Loading...
