Page 10
English Customer Service: 1-844-FIRMAN1
6. The remote control is programmed to generator
successfully.
START
Battery Cable Connection
1.Unscrew the air cleaner cover by provided
screwdriver.
2. Cut wire tie that is binding the black battery
cables A and B.
3. Insert the male connector of cable A into
female connector of cable B.
4. Reattach the air cleaner cover.
5. Push the "START" button on the remote
control and hold on. Release the button when
the indicator light become off.
Follow below instruction to connect battery to
the generator:
While the Engine Switch is in the “RUN” (I) position
and the battery power restore switch has been
pressed for about 3 seconds, the remote module is
active and waiting for signal. This function requires
electrical current which is consuming the battery.
Remote Control Power Consumption
THIS GENERATOR WILL AUTOMATICALLY
DISCONNECT THE BATTERY AFTER 12 HOURS
TO AVOID BATTERY DRAINAGE, IF THE
GENERATOR IS NOT RUNNING AND THE ENGINE
SWITCH IS LEFT IN “RUN” (I) POSITION.
YOU MUST GO THROUGH STARTING PROCEDURE
TO RESUME RUNNING THE UNIT AGAIN.
To Next Page
Loading...
