OPTIONAL
To prevent loosening, apply one drop of Thread Lock on the threads of each spoke.
NOTE: Thread Lock is not included. Purchase from your local hardware store.
oPeninG SaFe For tHe FirSt tiMe
87
inStaLLinG tHe HandLe SPoKeS
2
Screw spokes into the handle hub.
1
Locate two (2) additional spokes inside
safe and remove protective covers.
Follow OPENING SAFE FOR THE FIRST TIME on page 7 before proceeding.
Follow REMOVING THE SAFETY INTERLOCK SCREW and BATTERY INSTALLATION on
pages 5-6 before proceeding.
1
Turn handle counter-clockwise until it stops.
2
Enter the six (6) digit factory preset
passcode 1-2-3-4-5-6. (The lock will
beep two (2) times).
3
Within four (4) seconds, turn the handle clockwise.
4
Pull door open.
5
With the door open, turn handle counter-clockwise
and lock door bolts in open position.
6
Test passcode 1-2-3-4-5-6 several times before closing and locking door.
WARNING
The lock will beep three (3) times if an incorrect passcode is entered.
If a mistake is made, wait thirty (30) seconds and repeat steps 1-6.
To Next Page
Loading...
