SECURITY CODES
General
At the time of installation, your installer programmed a personal four-digit
Master code, known only to you and yours. This code is used to perform
most system functions, including arming and d&arming of the system. As an
additional safety feature, temporary user codes can be assigned (see next
page) for use by those not having a need to know the Master code. Note
that the Master code remains in effect even when other user codes are
assigned.
Duress Code
to disarm or arm the
normally, but can
service has been
Important: The Duress code is useful only when connected to a central
station.
Quick hing
If your system supports ‘Quick Arming”, the V”
ke
place of the security code when arming the system.
f-h
can be pressed in
required, however, when disarming the system.
e security code is
-1 o-
To Next Page
Loading...
Need help?
General
