– 54 –
Using #77 Instant Activation Mode (cont’d)
Additional Commands
Action Code
Action Specifier
77 Access Point Group Enable Group #
78 Access Point Group Disable Group #
To enter the Instant Activation Mode:
Enter your security code; then press the [#] key followed by 77.
ACTION ?
Enter the code for the desired action. The
action codes are the events that are to take place
when either the system exits the #77 Mode or the
scheduled time is reached, depending on the action
selected.
Press [✳] to continue.
Enter the action specifier. This defines what the
action will affect (relay, relay group, partition, zone
list, user group). The action specifier screen prompt
varies, depending on the type of action selected.
As an example, if you selected “Auto Bypass” as the
action, the action specifier prompt would be:
ZONE LIST?
ARE YOU SURE?
1 = YES 0 = NO 0
Enter 1 (YES) or 0 (NO).
Press [✳] to continue.
QUIT MENU MODE?
1 = YES 0 = NO
Enter 1 (YES) or 0 (NO).
Press [✳] to continue.
To Next Page
Loading...
Need help?
General
