1. Read and review all safety information and product guidelines.
2. Inspect all product components for factory defects.
3. Dispose of product packaging components properly.
Standard Components
Getting Started
Heater Unit Cable Mat
Pump
Before First Use
Initial Setup
1. Connect the hose assembly to the heated water
connector at the rear of the unit. There is no
dedicated input or output allowing both hoses to
be inserted into either connector.
2. Open the cap at the top of the unit by turning
the handle counterclockwise until the cap unfastens.
3. Carefully pour water at room temperature into
the opening at the top of the unit. Pour until
the water level reaches the inside of the small
filler assembly. For further assurance, the LCD
will display the water level inside.
4. CAUTION – Excess water may release from the
center of the cap.
5. Secure the cap by turning it clockwise.
Safety Surface Pin
Power Adapter Input
Hose Connector
English
User Manual
05
English
06
Temp er at ure B ut to n
Time Button
Water Level
Temp er at ure
Time Display
Power Button
Status Display
To Next Page
Loading...