Firstech Blade Series - Module Programming Procedure - With KLON; Initial Setup and Button Press; Key Insertion and Ignition Cycle; Programming Confirmation and Completion

Patent No. US 8,856,780 CA 2759622
INSTALL GUIDE
WWW.IDATALINK.COM Automotive Data Solutions Inc. © 2020
ALL IN ONE
DODGE/RAM
MODULE PROGRAMMING PROCEDURE - WITH KLON
9
Turn key to ON position.
ON
4
Turn key to ON position.
ON
15
Turn key to ON position.
ON
11
Turn key to OFF position.
OFF
6
Turn key to OFF position.
OFF
17
Turn key to OFF position.
OFF
19
Turn key to OFF position.
OFF
20
Module Programming
Procedure completed.
1
Close driver door.
Re-open driver door to wake up
data bus.
2
Press UNLOCK on OEM remote.
If the vehicle is not equipped
with an OEM remote, press the
module programming button.
7
Remove key.
8
Insert key into ignition.
3
Wait, LED will fl ash BLUE once
[1x].
5
Wait, LED will turn solid RED.
10
Wait, LED will fl ash BLUE.
16
Wait, LED will turn solid BLUE
for 2 seconds.
14
WARNING: Do not press RS
programming button.
Connect power fi rst.
Connect RS to vehicle.
13
Connect RS to computer
and proceed with extended
programming.
12
WARNING:
Disconnect power last.
Disconnect RS from vehicle.
18
Turn key to START position.
START
COM-BLADE-AL(DL)-CH8-EN 20191004
Doc. No.: ##65995##