To Next PageTo Next PageWhat to do if the Fisher & Paykel Dishwasher tub cannot drain?
If the Fisher & Paykel Dishwasher tub won't drain, use the diagnostic hardware output mode to start the drain direction (P2). Does the product drain? Also, check if the drain hose is blocked. Inspect the rotor for damage or obstructions.
What to do if my Fisher & Paykel Dishwasher shows A1: Water Supply error?
If your Fisher & Paykel Dishwasher displays an A1 error related to the water supply, several factors could be the cause. First, ensure that the incoming water pressure and flow rate are adequate. If there is no water in the tub, enter the hardware output mode and run the fill valve to check if the water supply is connected. Also, inspect the hose filters for any blockages and clean them, or replace the fill valve if needed. Make sure there is no foam in the tub. Lastly, verify that the motor rotor is undamaged and replace it if necessary, as it may be damaged.
General| Product Type | Dishwasher |
|---|---|
| Style | Built-In |
| Noise Level | 44 dBA |
| Finish | Stainless Steel |
| Control Type | Electronic |
| Energy Star Qualified | Yes |
| Material | Stainless Steel |
| Color | Stainless Steel |
| Width | 600 mm |
| Depth | 573 mm |
| Height | 820 mm |
| Number of Programs | 6 |
| Number of Wash Cycles | 6 |
| Features | Half Load Option |
| Drying System | Fan assisted drying |
