What to do if the Fisher & Paykel Dishwasher tub cannot drain?
If the Fisher & Paykel Dishwasher tub won't drain, use the diagnostic hardware output mode to start the drain direction (P2). Does the product drain? Also, check if the drain hose is blocked. Inspect the rotor for damage or obstructions.
What to do if my Fisher & Paykel Dishwasher shows A1: Water Supply error?
If your Fisher & Paykel Dishwasher displays an A1 error related to the water supply, several factors could be the cause. First, ensure that the incoming water pressure and flow rate are adequate. If there is no water in the tub, enter the hardware output mode and run the fill valve to check if the water supply is connected. Also, inspect the hose filters for any blockages and clean them, or replace the fill valve if needed. Make sure there is no foam in the tub. Lastly, verify that the motor rotor is undamaged and replace it if necessary, as it may be damaged.
General| Brand | Fisher & Paykel |
|---|---|
| Model | DISHDRAWER DD60STI9 |
| Category | Dishwasher |
| Language | English |
General safety precautions for using the dishwasher, including warnings and intended use.
Guidelines and precautions for the safe installation of the dishwasher.
Procedures for safe cleaning, maintenance, and electrical connection.
Safety precautions to follow during the operation of the dishwasher.
Explains options like Extra Dry, Quick, and Sanitize to enhance wash performance.
Instructions to determine water hardness and set the built-in softener.
Steps for filling the salt reservoir and indicator light meanings.
How to clean the drain filter, filter plate, and spray arm for optimal performance.
Solutions for problems like unclean dishes, hard water, and water leaks.
Troubleshooting detergent problems, foaming, and drawer operation.
Resolving issues with dishwashers not starting, opening, or making fan noise.
Solutions for poor drying performance and interior stains.
To Next Page
