6
8 TOE KICK INSTALLATION OPTIONS
PRE-FINISHED TOEKICK
Measure the distance between the floor and
the base of the door to establish the toekick
height. Refer to the above guide and mark
out the cut location.
Remove the brackets from the
product and secure to the toekick
using Ø4 x 13mm screws. Slide the
toekick into the spaces on either side
of the chassis and mark the desired
depth on the bracket. Remove
toekick and, using a screwdriver,
bend the marked tabs out on both
brackets.
Carefully lay the toekick face down
on a cutting surface and use a sharp
knife to score along the panel. Turn
over and score the other side before
gently snapping off the excess. A
file can be used to smooth off any
rough edges.
Slide toekick firmly back into the
product to attach. The bent tabs will
prevent the toekick receeding into the
product further than desired.
Distance between
bottom of door
and floor (mm)
Cut
location
105 - 100
9
110 - 105
8
115 - 110
7
120 - 115
6
125 - 120
5
130 - 125
4
135 - 130
3
140 - 135
2
145 - 140
1
145+ N/A
9
8
6
4
7
5
3
2
1
TOEKICK PROFILE VIEW
To Next Page
Loading...
