15
Installation instructions
Anti-Tilt Bracket
Important!
To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear
to fix it securely to the wall.
To fit the anti-tilt bracket:
1
After you have located where the cooker is to be positioned, mark on the wall the place where
the two screws of the anti-tilt bracket have to be fitted. Please follow the indications given in Fig.
10.
2
Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not damage any pipes or electrical wires.
3
Loosely attach the anti-tilt bracket with the two screws supplied.
4
Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can engage in
the slot on the cooker’s back, as shown in fig. 10.
5
Tighten the screws attaching the anti-tilt bracket.
6
Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot on the
cooker’s back.
Anti-tilt bracket
Existing slot in rear of cooker
Dotted line showing the
position of cooker when installed
Figure 10 Fitting a stability bracket
To Next Page
Loading...
