15
Selecting a programme and operating your machine
Changing the selections after the programme has started
Turning the programme knob while the programme is in operation will not change the
programme.
The programme needs to be paused or cancelled before changes can be made.
Door lock
The loading door cannot be opened whilst the READY lamp is flashing due to safety reasons.
Once the READY lamp lights continuously the door is able to be opened.
Adding additional laundry
Press the START/PAUSE button to pause the programme.
If the water level does not exceed the preset limits, in 1 to 2 minutes the door lock will be
deactivated. Laundry may be added / taken out by opening the door.
If, after 2 minutes, the door is unable to be opened, it means that the water level inside
the machine is too high for the door to be opened and laundry added (refer to ‘Cancelling
the programme’).
Pausing the programme
Press START/PAUSE button momentarily to switch your machine to the standby mode.
Additional functions can be cancelled or selected according to the stage of cycle the current
programme is at.
Cancelling the programme
If the programme has started and you want to cancel it:
1
Press and hold the START/PAUSE button for 3 seconds.
2
The programme will progress to the SPIN step.
3
The water will be drained, and after 1 –2 minutes the door can be opened.
Note: the READY warning lamp flashes during cancelling and then END will appear on the display.
To Next Page
Loading...
Need help?
General
