14
MENU
(Continued)
NOTCH
The Notch control allows you to accept or reject different types of metals per
each target category group. All categories are eligible for NOTCH. Each mode:
Jewelry, Coin, Artifact and Custom has its own set of notches.
With Notch menu active, press “+” or “-“ to program the Notch feature. Each
press of the “+” or “-“ cycles to a new category and the active position is
indicated by a flashing icon. Select desired category and wait 5 seconds or
press the menu button for immediate notch setting. That category will reverse
status. If the icon had previously been illuminated it will now disappear
indicating the category has been eliminated from detection. Likewise, an icon
that is not visible on the display will re-illuminate, indicating that category is
now notched in and targets will be detected.
All of the 9 target categories can be notched, but only one category can be
notched at a time. All Notch settings are saved when the detector is turned off.
MODES
There are four different preset modes: Jewelry, Coin, Artifact and Custom.
Each of these modes have specific audio tones, see the section labeled
4-Tone Target Identification for specific details. The active mode
indicator is displayed on the right side of the screen.
Jewelry Mode: Fe (Iron) category notched out.
Coin Mode: Fe (Iron) and Target Category groups 2 (Foil) and 4
(Aluminum) notched out.
Artifact Mode: All Target Categories enabled.
Custom Mode: User definable.
Each of the four Modes can be changed by notching target category groups in
or out. Settings are saved at power down. To reset your F22 to the preset
factory settings:
1. Turn the detector off.
2. Hold the MENU button down while pressing the Power button.
NOTE: This reset will erase any custom tone settings you may have entered
in the Custom Mode.
.
CUSTOM MODE PROGRAMMABLE TONES
To program your Custom mode tones:
1. Press button until CUSTOM is activated.
2. Press and hold for approximately 1 second.
3. Press button to cycle through target categories.
4. To select a tone for the desired category, press “+” or “-“ to cycle
through 5 tone options (0=VCO, 1=bass, 2=low, 3=medium, 4=high).
5. To exit the tone selection mode, press
.
6. To continue setting tones for additional categories Press to set
selection and cycle to next target category. To exit the tone selection
mode, press .
To Next Page
Loading...
Need help?
General
