Instruction Manual
D200138X012
3582, 582i, and 3583
February 2015
7
Refer to the unit nameplate to determine the type of positioner or transmitter, supply pressure, etc.
WARNING
This product is intended for a specific current range, temperature range and other application specifications. Applying
different current, temperature and other service conditions could result in malfunction of the product, property damage or
personal injury.
Educational Services
For information on available courses for 3852, 3582i and 3583, as well as a variety of other products, contact:
Emerson Process Management
Educational Services, Registration
Phone: +1-641-754-3771 or +1-800-338-8158
e‐mail: education@emerson.com
http://www.emersonprocess.com/education
Installation
If using natural gas as the pneumatic supply medium, natural gas will be used in the pressure connections of the unit
to any connected equipment. The unit will vent natural gas into the surrounding atmosphere, unless it is remote
vented.
WARNING
Always wear protective clothing, gloves, and eyewear when performing any installation operations to avoid personal
injury.
If installing into an existing application, also refer to the WARNING at the beginning of the Maintenance section in this
instruction manual.
Check with your process or safety engineer for any additional measures that must be taken to protect against process
media.
WARNING
Personal injury or property damage may result from fire or explosion if natural gas is used as the supply medium and
appropriate preventive measures are not taken. Preventive measures may include, but are not limited to, one or more of
the following: Remote venting of the unit, re‐evaluating the hazardous area classification, ensuring adequate ventilation,
and the removal of any ignition sources.
3582i does not meet third party approvals for use with natural gas as the supply medium. Use of natural gas as the supply
medium can result in personal injury or property damage from fire or explosion.
To Next Page
Loading...