Fisher CR-5125 - Page 4

DISASSEMBLY INSTRUCTIONS
COVER REMOVAL
1. Remove four screws (1 — 4) and four washers fastening the
Cover.
2. Lift cover off.
3. Reassemble in reverse order.
SHEET PANEL REMOVAL
1. Turn the unit over onto a clean soft surface.
2. Remove the four Legs by removing the four screws (5 — 8).
3. To take off the Sheet Panel, remove two screws (9 — 10).
.—
=(9)
4. Reassemble in reverse order.
COMPLETE FRONT PANEL REMOVAL
1. Follow the instructions for Cover Removal.
2. Pull out the seven Switch Knobs (A —G) and the INPUT
Level Control Knobs (H and I).
3. Turn the unit over onto a soft surface and remove the three
screws (11 — 13) fastening the lower side of the Front Panel.
@ @)
(2) ®
@DARKAK eee
see A®
4. Place the unit in an upright position and remove the three
screws (14— 16) fastening the upper side of the Front
Panel.
Ohi
5. Pull out the two connectors (CN3 and CN8) from the
Amplifier Base P.C.Board. Then, remove the connector lead
wires from the wire band.
6. Remove the three spacers (J — L) and pull the Complete
Front Pane! off the unit.
REAR PANEL REMOVAL
1.
Follow the instructions for Cover Removal.
2. Remove the nine screws (17 — 25) fastening the Rear Panel.
Then, remove the two screws (26 and 27) holding the Jacks
(LINE IN and LINE OUT) to remove the Rear Panel.
Ta | |e ||
ree a ® @ i || ae A -
@@ P=
On—
3. Reassemble in reverse order.
—4~—