Fisher CR-5125 - Page 8

MECHANICAL
ADJUSTMENTS
(Continued)
3. Insert a screwdriver into the adjusting hole as illustrated and
turn the screwdriver to obtain the clearance of “‘0’’ between
the Slide Base and the spacer. Then, check to see that there
is clearance between the Pinch Roller Arm and Slide Base.
Adjustment
ANS
Capstan
Spacer
Slide Base
() CHES
4. After the adjustment, tighten the fastening screws and
secure them with paint or glue. Then, take out the Spacer
from the Solenoid after the STOP button is pushed.
STOP SOLENOID MOUNTING
* Mount the Stop Solenoid, using the following procedures
whenever it is replaced or removed.
1. Mount the Stop Solenoid on the Completed Select Button
by temporarily tightening the two screws.
2. Press the Solenoid in the direction of the arrow as illustrated
and tighten the fastening screws.
Screw Screw
Stop Solenoid
3. After mounting, secure the screws with paint or glue.
FLYWHEEL ADJUSTING SCREW ADJUSTMENT
1. While moving the Capstan up and down as illustrated, slowly
turn the Flywheel Adjusting Screw clockwise to obtain the
clearance of ’’0’’ between the Adjusting Screw and Flywheel.
Adjustment
a
Adjusting Screw
Adjustment
cs.
djusting Screw
Supporter
Flywheel
NOTE:
Do not turn the Flywheel Adjusting Screw forcibly.
2. Turn the Screw counter-clockwise by 45° — 90° from the
position obtained in Item 1.
3. After the adjustment, secure the Screw with paint or glue.
4. Perform the same adjustment for the other adjusting screw.