Fisher Design RSS - User Manual

D101299X012
Design RSS Lined Valve
Contents
Introduction 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Scope of Manual 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Description 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Specifications 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation 3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Maintenance 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Packing Maintenance 5. . . . . . . . . . . . . . . . . . . . . . . . .
Replacing Packing and Bushing Inserts 5. . . . . . . . .
Trim Maintenance 7. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disassembly 7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Assembly 8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts Ordering 9. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts List 11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Introduction
Scope of Manual
This instruction manual includes installation, mainte-
nance, and parts information for 1/2- through 4-inch
Design RSS lined globe valves. Refer to separate
manuals for instructions covering the actuator, posi-
tioner, and accessories.
Description
The Design RSS lined globe-style valve (figure 1) has
pure-modified PTFE trim parts, push-down-to-close
action, and positive shutoff. This valve is intended for
applications involving severely corrosive and toxic
flowing media. The Design RSS valve body provides
an economical alternative to alloy valve bodies in a
wide variety of applications.
Only personnel qualified through training or experience
should install, operate, and maintain this control valve.
Figure 1. Design RSS Valve with Type 667 Actuator
and Type 3582 Positioner
W4453–1 / IL
If you have any questions concerning these instruc-
tions, contact your Fisher Controls sales office or
sales representative before proceeding.
Specifications
Specifications for the Design RSS valve are shown in
table 1. If the valve is shipped with the actuator, some
of the valve specifications are on the valve nameplate,
which is attached to the actuator. If the valve is
shipped without the actuator, the valve nameplate is
wired to the valve.
Instruction Manual
Form 5592
January 1999
Design RSS

Fisher Design RSS Specifications