Instruction Manual Supplement
D104328X012
DVC6200 Digital Valve Controller
February 2018
5
WARNING
Personal injury or property damage, caused by unexpected valve movement, could result if the digital valve controller is
put in service with the connector arm or array moved from its original position.
If the connector arm or array is moved, the digital valve controller must be calibrated before putting it in service. Refer to
the appropriate instruction manual or quick start guide for calibration information.
Ensure that air and signal is supplied to the digital valve controller and remove mechanism for locking the valve in
place. Allow for a slow transition from manual to auto loop control.
Note
For a DVC6200 on a DeltaV system go to Detailed Setup to ensure the input units are set to 0 - 100%.
Note
To ensure greater accuracy, perform an auto travel calibration on the digital valve controller when conditions allow.
Related Documents
D Fisher FIELDVUE DVC6200 Series Digital Valve Controller Quick Start Guide (D103566X012)
D Fisher FIELDVUE DVC6200 HW1 Digital Valve Controller Instruction Manual (D103409X012
)
D Fisher FIELDVUE DVC6200 HW2 Digital Valve Controller Instruction Manual (D103605X012
)
These documents are available from your Emerson sales office
or Local Business Partner, or at www.Fisher.com.
Emerson Automation Solutions
Marshalltown, Iowa 50158 USA
Sorocaba, 18087 Brazil
Cernay, 68700 France
Dubai, United Arab Emirates
Singapore 128461 Singapore
www.Fisher.com
The contents of this publication are presented for informational purposes only, and while every effort has been made to ensure their accuracy, they are not
to be construed as warranties or guarantees, express or implied, regarding the products or services described herein or their use or applicability. All sales are
governed by our terms and conditions, which are available upon request. We reserve the right to modify or improve the designs or specifications of such
products at any time without notice.
E 2017, 2018 Fisher Controls International LLC. All rights reserved.
Fisher, FIELDVUE, ValveLink, and Trex are marks owned by one of the companies in the Emerson Automation Solutions business unit of Emerson Electric Co.
Emerson Automation Solutions, Emerson, and the Emerson logo are trademarks and service marks of Emerson Electric Co. All other marks are the property
of their respective owners.
Neither Emerson, Emerson Automation Solutions, nor any of their affiliated entities assumes responsibility for the selection, use or maintenance
of any product. Responsibility for proper selection, use, and maintenance of any product remains solely with the purchaser and end user.
To Previous Page
Loading...
Need help?
General
