Lit. No. 43069, Rev. 05 10 May 1, 2019
86000, 86000-1, 86100(CH), 86100-1(CH), 86200, 86205, 86205-1, 86300, 86400
86600-3, 86610-3(CH), 87000, 87000-1, 87100, 87200, 87300, 87400, 87600-3
AeroShell
®
is a registered trademark (
®
) of Shell Oil Company.
3. Turn the control ON and completely extend and
retract the driver-side wing several times. Repeat
for the passenger-side wing. With both wings fully
retracted, raise and lower the snowplow several
times. Activate the control FLOAT function and
manually collapse the lift ram all the way. Turn the
control OFF.
4. Remove the fi ll plug and check the fl uid level.
With the snowplow wings and lift ram fully
retracted, the fl uid level should reach the fi ll hole.
If additional fl uid is needed, fi ll the reservoir
with FISHER
®
EZ Flow Hydraulic Fluid rated
to –40°F (–40°C), or other fl uid conforming to
Military Specifi cation MIL-H-5606 A, such as
Mobil Aero HFA or Shell AeroShell
®
Fluid 4.
NOTE: Remove the fi ll plug slowly to relieve any
pressure in the reservoir.
NOTE: Add fl uid only when all rams are retracted.
5. Replace and tighten the fi ll plug.
HYDRAULIC UNIT
The XV2™ snowplow hydraulic system comes from
the factory pre-assembled, partially fi lled, and fully
tested.
1. Attach the snowplow to the vehicle according to
the instructions on the headgear.
2. Remove and discard the factory-installed pipe
plug from the top of the reservoir and install the
breather.
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between the vehicle and the blade or directly
in front of the blade. If the blade hits or drops
on you, you could be seriously injured.
CAUTION
Do not mix different types of hydraulic fl uid.
Some fl uids are not compatible and may cause
performance problems and product damage.
Fill
Plug
Drain
Cap
Breather
FLUID CAPACITY
• Insta-Act
®
Unit Reservoir 1-3/4 quarts
• Insta-Act System Total 2-3/8 to 2-3/4 quarts
WARNING
To prevent accidental movement of the blade,
always turn the control OFF whenever the
snowplow is not in use. The power indicator
light will turn OFF.
To Next Page
Loading...