Lit. No. 43069, Rev. 05 14 May 1, 2019
86000, 86000-1, 86100(CH), 86100-1(CH), 86200, 86205, 86205-1, 86300, 86400
86600-3, 86610-3(CH), 87000, 87000-1, 87100, 87200, 87300, 87400, 87600-3
Adjusting the Center Cutting Edges
The center cutting edge gap setter is located on the
T-Frame below the pivot pin hinge.
1. Place the blade wings in straight position and
check whether the center cutting edges touch the
center cutting edge gap setter. If they do not touch
the gap setter, adjust the center cutting edges as
follows.
2. Loosen the four 5/8" x 2" center cutting edge
carriage bolts, but do not remove them.
3. Slide the center cutting edges inward until they
contact the gap setter.
4. Re-tighten the center cutting edge carriage bolts
according to the torque chart.
5/8" x 2"
Carriage Bolts
Gap Setter
Center
Cutting Edge
Gap Setter
Lubricating the Pivot Pin Hinge
Using a rubber-tipped seal-off coupler fi tting, apply a
good quality multipurpose grease at the fi ve grease
points along the center hinge of the blade.
Lubricating the 10.5' Pivot Beam
Using a rubber-tipped seal-off coupler fi tting, apply a
good quality multipurpose grease at the three grease
points along the pivot beam bolt before tightening the
jam nut and locknut.
Grease
Points
7.5'/8.5'/9.5' XV2™ Blade Shown
Grease Points
To Next Page
Loading...