Fishman PRESYS I - Presys I Quick Start Guide; Set the Controls; Plug In; Tune Up

2
Presys I Quick Start
1. Set the controls • Set volume off and the contour control to off (button
out).
2. Plug in • Connect the Presys I to an amplifier or PA with a ¼-inch instrument
cable. The light will flash once quickly to indicate it has switched on.
3. Tune up • Press the tuner button. When it’s on, the tuner mutes the
signal. Press again to exit.
4. Turn up • Raise the volume and adjust the contour control to your liking.
contour phase