5
Cabling Precautions
When making your cable connections, always be sure to route the cables
so that your audience, performers, or anyone else, will not trip over them or
accidentally pull the SA330x over.
Setting SA330x Controls
1. Locate the Power switch and switch
it off, then connect the AC line
cord into the back of the SA330x.
2. Plug the SA330x into an electrical
outlet with the appropriate AC
voltage.
3. Push in the Mute switch and turn
on the Power switch.
4. Connect your instrument or other
audio source to the Channel 1
input with an appropriate mic or
instrument cable.
5. Play your instrument or other
source material to the loudest
level you anticipate during your
presentation or performance and
raise the Channel 1 Gain knob until
the Clip LED flashes, then back off
the Gain until no clipping occurs.
6. Set the controls as shown in the
drawing.
7. Push the Mute switch (out) and
slowly raise the Master Volume to
the desired level.
To Next Page
Loading...
Need help?
General