7
For more detailed instructions please visit www.fishman.com/tripleplay
TriplePlay Hardware Installation Quick Start (continued)
Preparing a Tune-O-Matic Bridge Bracket:
In order to properly install the Tune-O-Matic Bridge Bracket, you will need to remove the strings on
your guitar. The supplied bracket is designed to fit on the bridge mount posts. You may need to
re-adjust the height of the bridge after installing the bracket, as it may add some height to the
bridge assembly. The hex-pickup mount will be affixed to this bracket.
2
Place the bridge back onto the bridge
mount posts and replace the strings on your
guitar.
1
After removing the strings, lift the bridge
off of the bridge mounts. Fit the supplied
Tune-O-Matic Bridge Bracket onto the
bridge mount posts so that the bracket sits
between the bridge and bridge pickup.
3
The tension of the strings will hold
everything in place. This bracket is where
you will mount the hex-pickup.
Proceed to the section "Mounting the hex-pickup
on your guitar"
To Next Page
Loading...
