10
For more detailed instructions please visit www.fishman.com/tripleplay
TriplePlay Hardware Installation Quick Start (continued)
Mounting the hex-pickup on your guitar:
Carefully slide the hex-pickup out of the
mount, then press down and rub along the
top of the mount to ensure that there is
good adhesion to the guitar body. The Pickup
Mount will remain on your guitar.
Note: The adhesive used for this method is removable,
however use caution when doing so in order to protect
the surface finish of your instrument. Sliding dental floss
along the underside of the adhesive is an effective
method for removing the bracket.
4
3
Once you have chosen the best Pickup
Mount, re-insert the hex-pickup into it,
peel off the adhesive backing, and
carefully slide the assembly underneath the strings
without allowing it to touch the face of the guitar.
Shift this assembly as close to the bridge as
possible. As the hex-pickup is magnetic, allow the
strings to hold it in place while you carefully adjust
the pickup so that the strings line up in the center
of each of the six pickup elements. Once
positioned, press the assembly down onto the
face of the guitar, and hold for 30 seconds.
To Next Page
Loading...
