Fishmaster Pro Series - Tools and Materials Required

Reference 20FEB2018 Pg 5 of 16 Copyright 2018 Fishmaster
The above hardware is included with your Fishmaster Pro Series T-Top and are
referenced to in the installation of the tower by their item number. The following are
items the customer supplies to complete the installation.
Items and tools needed for Installation
The following items will be needed for the installation of the T-Top and are not
supplied.
Customer Supplied Tools
Reversible Drill
3/16” Drill Bit (A 3/8” x 12” long wall bit is recommended for standoff installation)
Phillips head screwdriver or drill with Phillips bit
Masking Tape, Tape Measure & Pencil
Large or up to 4’ long Level to make sure the boat and parts are square and level during
installation. Sometimes 2 can help as well.
Friend to help hold & hand things
Safety Glasses (always use when drilling fiberglass or metal)
Shop-vac or Vacuum for drill shavings and fiberglass from mounting bases and standoffs
Rubber mallet is recommend for adjusting leg width
Hammer and Center Punch is recommended to start all holes before drilling
Customer Supplied Materials
For Roplene™ boats like Triumph use “Sudbury Elastomeric Sealant” by Rule, available at your
local Triumph dealer or many retailers and online stores
White Lithium or similar marine grease for rotating points and bolts
Non-Permanent Loctite for side hinge bolt and standoffs.
12 Zip Ties or pieces of twine/rope 10” or longer for centering Cover on Canopy Frame
Main Assembly