SECTION 1
Safety guidelines & definitions
SECTION 2
Unit safety warnings
Do not operate the Nitro-Draught unit until the information contained in this document has been read
and understood by all personnel concerned. The unit should be connected to an electrical supply in
accordance with local safety regulations. Ensure that the rating plate corresponds to the supply
voltage. Ensure that the unit is grounded.
Nitrogen (N
2
) & carbon dioxide (CO
2
) are not poisonous gases but in a concentrated form present a
risk of asphyxiation. The Nitro-Draught unit produces a small flow of mixed gases that quickly
disperse in the atmosphere. However, do not directly inhale any gases produced by the unit. Refer to
Compressed Gas Association publications for further information.
Before service or maintenance is performed on the Nitro-Draught system, the electrical supply must
be switched off and the main electrical cord disconnected. All personnel handling, using or
maintaining the Nitro-Draught unit must employ safe working practices and observe all relevant local
health and safety regulations.
WARNING: The WARNING symbol draws attention to an operating
procedure or practice that can cause injury if it is not observed or
performed correctly. Do not continue past a WARNING symbol until you
have fully understood or satisfied the indicated conditions.
CAUTION: The CAUTION symbol draws attention to an operating
procedure or practice that can damage the unit if it is not observed or
performed correctly. Do not continue past a CAUTION symbol until you
have completely understood or satisfied the indicated conditions.
To Next Page
Loading...