Page 5 of 12 NA v2.3
PROPER LOCATION
• When operating the system, choose a clean, flat surface where it can be placed,
away from heat and where you have plenty of room above and around the unit to
operate the system.
• Beer System unit dimensions: 11.66 W x 17.75 H x 7.01 D.
• The following dimensions are recommended for clearances around the system when
in use:
Sides 8 inches Front & Back 10 inches
• The Fizzics system is designed for both indoor and outdoor use.
PREPARING THE SYSTEM FOR FIRST TIME USE
Please follow all of these directions before you use your system for the first time.
• Slide open the small cover on the top of the lid and insert 4 AA (4 double A)
batteries. (Batteries are not included with the Fizzics system).
• When inserting the batteries, make sure they follow the correct polarities and touch
the metal contacts. Avoid reversing the + and –polarities.
• Close the small battery cover by sliding it back until it locks into place.
• Open the lid of the system, place a glass with warm water into the system canister.
• Insert tube into the glass of water.
• Close the lid of the system and secure the lid by locking the two side clasps into
place.
• Place a glass of the same size onto the antimicrobial mat.
• Now push the lever forward to clean the system until the water from the glass inside
the system canister runs out of water.
• Unlock the two clasps, open the lid and remove the empty glass.
• You are now ready to use the system to dispense beer.
To Next Page
Loading...
