Flama 4585FL - Page 17

15
English
When preheang is over, the set me will
ash in the me indicator of the display.
The appliance will beep and the operaon
indicator will turn green.
Press the START buon.
NOTE - If the START buon is not pressed
within 15 seconds, the appliance will go on
standby mode; The word ‘OFF’ will appear
on the display.
Place the food on the plate and press the
START buon; countdown will start and the
operaon indicator will turn yellow.
When countdown is over, the device will
beep, the word ‘donE’ will appear on the
display, and the operaon indicator will
turn red.
Press the CANCEL buon in standby mode
and the word ‘OFF’ will appear on the
display.
Open posion (180º)
WARNING - Be very careful when placing
the upper tray in the open posion, as it is
hot aer preheang and can cause burns.
When preheang is over and the operaon
indicator is green, use the handle to move
the upper tray to the open posion.
Using a heat-protecon glove (or similar),
press the top tray to level it with the handle.
Then move the handle with the top tray to
the open posion.
NOTES:
For a beer result, add some cooking oil or
cooking spray to the food.
Close the grill to reduce the preheang
me.
Use only the handle to open or close the
top tray.
While cooking, you can press the CANCEL
buon to stop the grill operaon and
change which plate to use (upper, lower, or
both).
While cooking, press the increase or
decrease buons to adjust the me and/
or temperature; the appliance assumes
the new me/temperature seng aer 3
seconds.
When the appliance is on Standby mode,
press the temperature increase and
decrease buons simultaneously for 3
seconds to change from degrees Cengrade
(°C) to degrees Fahrenheit (°F).
The appliance memorizes the last seng,
can memorize the last temperature and
me seng; when turning on the unit
and selecng the desired funcon, the
temperature and me seng of the last
use will appear on the display.
The appliance memorizes the last
temperature and me seng; when turning
on the appliance and selecng the desired
funcon, the temperature and me seng
of the last use will appear on the display.