Flama 5501FL - Troubleshooting

23
English
TROUBLESHOOTING
Problem Possible cause Possible soluon
The iron does not heat
up.
The iron is not plugged into
the wall outlet.
The selected temperature is
too low.
The fuse is burned out.
Plug the iron into the wall
outlet.
Increase the temperature
by using the temperature
buon. Be sure to
follow the maintenance
instrucons for the fabric.
Contact technical
assistance.
No steam is coming out.
There is not enough water in
the water tank.
The pump is sll drawing
water from the water tank.
Pour water in the water
tank.
Hold down the steam
buon so that water can
pump into the iron; it
may take approximately 1
minute.
Excess water drips from
the sole plate of the
iron.
Condensaon on the inside of
the sole plate.
Allow the iron to heat to
the selected temperature
before using.
The hose hums. The hose is tangled. Unwind the hose.
The temperature
indicator is not lit.
The appliance is not plugged
into the wall outlet.
The fuse is burned out.
Plug the iron into the wall
outlet.
Contact technical
assistance.