09
10
11
MODULE PROGRAMMING PROCEDURE - STD KEY - 1 OF 1
Close driver door.
Re-open driver door to wake up data bus.
Insert key into ignition.
Turn key to ON position.
LED will turn solid RED.
Within 5 seconds, LED will fl ash GREEN
rapidly.
Turn key to OFF position.
Remove key.
Press UNLOCK on the OEM remote. If vehicle
is not equipped with OEM remote, press
module programming button.
Wait, LED will turn solid GREEN for 2 seconds.
Module Programming Procedure completed.
www.flashlogic.comAutomotive Data Solutions Inc. © 2013
PAGE 13 OF 21
• 20131125
OEMCHRSCH5FLRSCH5EN
DOC.: #13103
To Next Page
Loading...
