07
>>
VALET MODE PROGRAMMING PROCEDURE - 1 OF 1
NOTE: In Valet Mode, the Remote starter is not
functional. Keyless entry, Lock and Unlock will
remain functional. See RF kit user manual for
alternate valet mode programming.
Insert key into ignition.
Time restriction. Complete next step within 7
seconds.
Turn key to OFF position then to ON position
fi ve times [5x] rapidly.
Wait, LED 1 will turn solid RED for 2 seconds.
Turn key to OFF position.
Remove key.
Valet Mode Programming Procedure
completed.
To exit valet mode: repeat steps 1 to 6.
www.flashlogic.comAutomotive Data Solutions Inc. © 2013
PAGE 14 OF 21
• 20131125
OEMCHRSCH5FLRSCH5EN
DOC.: #13103
To Next Page
Loading...
