01-3
Introduction
CHASSIS AND VEHICLE
IDENTIFICATION
Several numbers are used to identify the vehicle
and components used on the vehicle.
The V.I.N. or Vehicle Identification Number is
assigned by the chassis manufacturer and is the
number used for vehicle registration. The V.I.N.
is found on the Federal Certification Tag attached
in the driver’s compartment. Refer to this infor-
mation when ordering parts from the chassis
manufacturer or chassis dealer service center.
The F.I.N. or Fleetwood Identification Number
is located on the tag just outside the main entry
door or on the outside left front side of the motor
home. Use this number when ordering parts
through your Fleetwood dealer.
SUSPENSION ALIGNMENT
AND TIRE BALANCE
The front suspension and steering system of this
vehicle was accurately aligned at the factory
before delivery to the dealership. However, after
you have fully loaded the vehicle according to
your personal needs, have the alignment
checked and adjusted, if necessary. To help pre-
vent uneven tire wear, check the front-end align-
ment periodically.
Please note that front-end alignment after
retail delivery is the owner’s responsibility and
is not covered under the warranty.
Located in the driver’s compartment.
Located on the exterior left front side
of the motor home.
(Example)
(Example)
To Next Page
Loading...
Need help?
General
