reduce streaking. For persistent, stubborn stains,
use a whitewall tire cleaner. Follow directions
on the cleaner container.
Care
The TPO roof itself does not require annual
coatings or additional sealants. Periodic washing
with soap and water is all that is required.
The TPO roof material can be cut by sharp
objects. Use caution when loading sharp articles
on the roof. If you add accessories or new
equipment on the roof, be sure the installer is
qualified to work on the TPO roof material. This
is required under the terms of the warranty.
Repair kits are available through your dealer.
The roof requires special adhesives and mate-
rial. Do not use silicone sealants.
Door, Window, Roof Component
and Molding Resealing
Inspect the sealants around windows, floors,
joints and doors at least every three months.
Also inspect roof vents, other roof components,
moldings at front and rear caps, and perimeter
molding. If any of the following defects are evi-
dent during inspection, the affected areas must
be resealed.
• Sealant cracked or peeling.
• Void or missing sealant.
If you find any of the above defects:
1. Clean all areas to be resealed with an
appropriate cleaner and clean rags.
2. Make sure that all areas to be resealed are
absolutely dry before new sealant is applied.
ACRYLIC ASSIST HANDLES
(If Equipped)
Do not use any cleaners that contain ammonia,
petroleum, ammonia based, or petroleum based
products. Most glass cleaners are ammonia
based. Most tar removers are petroleum based.
Wash assembly with MILD SOAP AND
WATER ONLY!
INTERIOR
Fabrics
Interior appointments such as draperies, bed-
spreads, mattress covers, upholstery and wall
pads are manufactured from high quality materi-
als and should be dry cleaned only. Frequent
vacuuming will keep them free of dust and dirt.
Minor spills should be cleaned up quickly to
avoid staining. The affected area should be blot-
ted, not rubbed, to prevent the stain from work-
ing deeper into the fabric.
Solid Surface Top Care (If Equipped)
The counter top is constructed of a solid surface
material that requires little care. Routine care
involves wiping the surface with a damp cloth to
remove water marks. For stains, wipe with soapy
water or ammonia-based cleaners. Remove stub-
born stains on the “matte/satin” finish with an
abrasive cleanser.
Do not use lacquer thinner, nail polish remover, car-
bon tetrachloride, spot remover, gasoline, or naphtha
for any cleaning purpose. These products may cause
damage to the material being cleaned, and may be
highly flammable or poisonous.
11-3
Maintenance
NOTE
Do not seal the bottom flanges of windows and doors.
Special gaps in the sealant have been intentionally
left in the bottom flange to provide drainage.
WARNING
The TPO roof material is slippery when it is wet.
!
WARNING
!
To Next Page
Loading...
Need help?
General
